Apex Parts & Accessories

Trident Reagent Kit 6 Month Supply - With six month kits, the cost of running the Trident is less than $17 per month - that’s averages out to about 7 cents a test! Neptune Systems recommends keeping on hand no more Trident reagent than you might...

PLEASE ONLY PURCHASE 1x Two Month Supply.  We will not be able to restock any reagents for the next 30 days. 2-month reagent kit (based on the default testing schedule of 4-Alk/2-Ca/2-Mg per day).  The reagent kit has at least 240...

The Crossover Diet from Neptune Systems is a new type of food that was designed specifically for coral reef tanks and specifically for automatic feeding systems. Working closely with Reed Mariculture (the manufacturer of Reef Nutrition foods) we came up...

Neptune Systems Magnetic Probe Rack Features – MPR: Organizes up to four probes. Designed specifically for the Apex Controller probes, a perfect fit for the thicker temp probes. Built with an all acrylic weather and shatter resistant design...

Another American Marine first. ORP/REDOX calibration fluid. With a precise measurement of 400mV this calibration fluid is included with every PINPOINT® ORP Monitor and PINPOINT® ORP Controller. Occasional retesting with this fluid will keep your...

4-pin male to male cable many of you have been waiting for. It is ten feet long. This cable allows you to connect your DŌS to the 1LINK thereby eliminating the need for the DŌS to be connected to a power supply brick or the AquaBus cable. Just one wire!...

The PMUP is a multi-purpose pump that can be used for many different tasks on your aquarium. Automatic Top-Off (ATO) Carbon reactors GFO reactors Biopellet reactors Many other salt or freshwater uses NEW IN VERSION 2: Automatic shut off when...

This Energy Bar 832 was redesigned from the ground up.  Not only does it have eight 120V AC outlets, but it includes an internal 100W 24VDC power supply as well. That power supply feeds three built-in 1LINK ports as well as two 24VDC accessory ports...

DŌS Replacement Pump Head Cap for your Neptune Systems DŌS module.  Complete assembly includes cover, peri-tube, fittings and roller wheel. Neptune Systems recommends that these be replaced approximately every 700 hours of pump run time.

The DŌS comes standard with 4m of tubing. Many customers have been asking to purchase more tubing. We now have an available accessory — a 16-meter and 4- meter length of the tubing designed specifically for use with our DŌS.  Please...

PINPOINT® High-Precision pH Calibration Fluids come in plastic envelope packets and are extremely accurate and field portable. Each packet contains ample fluid for calibration (about 30 ml). There is a free sample of these included with each...

Usually used with a return pump, this flow sensor can be placed in line with the flow on any pipe, connected to the FMM, and communicate to your Apex the flow rate of water through that pipe. The flow sensor itself uses BSPP threads so for North...

Plug this probe into your FMM and then place it on any surface where you want to detect stray water. Upon contact with water this probe will communicate to your Apex and alerts or other actions can then take place.  Time is so critical when it...

Connect external switches and I/O Inputs to your Apex When connected to the I/O Port of your Apex, Apex Lite, or PMx module, the Breakout Box gives you an easy way to connect up to six external switch inputs to your Apex. Examples of things you might...

A redesigned display module has been created with a slick new look that matches the color scheme. Orange LED

The Kessil Apex Controller Cable connects the Kessil A360 or A160 LED Lights to the Neptune Apex Controller, and to Apex Jr. & Apex Lite Controllers with the VDM Module. 6 feet long.

This cable connects to the 24VDC accessory connections on the 1LINK. This cable has two bare (tinned) wires on the other end so you could connect it up to a 24VDC device of your choosing so long as it draws no more than 35W. Examples might include a...

The DŌS comes standard with 4m of tubing. Many customers have been asking to purchase more tubing. We now have an available accessory — a 16-meter and 4- meter length of the tubing designed specifically for use with our DŌS.  Please...

This is a power supply for the Neptune Systems FMM, DOS, ATK and Trident.

The Fluid Monitoring Kit Includes: 1x - FMM Fluid Monitoring Module 1x - 1" Flow Sensor (FS-100) 2x - 1/2" Flow Sensor (FS-50) 2x - 1" Unions 4x - 1/2" Adapters FMK What's In The Box? The FMM (Fluid Monitoring Module) is a multi-purpose...

Use this cable to connect Apex Systems and modules together. The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex,...

Use this cable to connect Apex Systems and modules together. The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex,...

The 1LINK module and the EB832 have two DC24 accessory outputs built that act like additional on/off outlets for DC24 devices. There are some Neptune Systems accessories, like our PMUP, that connect to these outputs directly.  There are...

The New Adaptive Reef Controller Cabinet is a modular wire management system for your aquarium equipment. Using interchangeable faceplates, you can mount and display all manner of controllers, modules, and dosers in a clean professional way to the front...

110V power supply for our DC24 accessories like the PMUP, GRO Refugium LED and Solenoid Valve.  You can use these when there are no available DC24 outputs on your EB832 or 1LINK but do have physical 110V outlets available.

Use this cable to connect Apex Systems and modules together. The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex,...

The PMUP is a multi-purpose pump that can be used for many different tasks on your aquarium.  This listing includes a Power Supply. Automatic Top-Off (ATO) Carbon reactors GFO reactors Biopellet reactors Many other salt or freshwater...

The perfect solution to help organize and control the rat's nest of wires that most aquariums suffer from.  This board was created to easily allow you to mount an apex, power strips, equipment controllers and much more so they are easily accessed an...

The Energy Bars available for our Apex systems are much more than a glorified power strip. In fact, this component of your aquarium controller equipment is far more important than most people realize – and not all systems are created equal! It...

Plug this probe into your FMM and then place it underneath your carpet near your aquarium. Upon contact with water this probe will communicate to your Apex and alerts or other actions can then take place. Don’t have carpet, see the next...

Usually used with aquarium accessories like reactors, carbon/GFO filters, etc., this flow sensor can be placed in line with the flow on any pipe, connected to the FMM, and communicate to your Apex the flow rate of water through that pipe. The flow sensor...

The New Adaptive Reef Controller Cabinet is a modular wire management system for your aquarium equipment. Using interchangeable faceplates, you can mount and display all manner of controllers, modules, and dosers in a clean professional way to the front...

Use this cable to connect Apex Systems and modules together. The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex,...

1LINK is the marrying of the Aquabus communication standard, along with the power wires to drive higher power devices, all in one single cable.  One of the benefits of this is to avoid the need for a DC power brick for every 24V device in your...

The perfect solution to help organize and control the rat's nest of wires that most aquariums suffer from.  This board was created to easily allow you to mount an apex, power strips, equipment controllers and much more so they are easily accessed an...

Mount your Vortech Pump Controller in style.

Usually used with a return pump, this flow sensor can be placed in line with the flow on any pipe, connected to the FMM, and communicate to your Apex the flow rate of water through that pipe. The flow sensor itself uses British Standard Parallel Pipe...

AQUABUS EXTENSION CABLE (M/F)-VARIOUS LENGTHS The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to extend a M/M Aquabus Cable. Remember,...

The perfect solution to help organize and control the rat's nest of wires that most aquariums suffer from.  This board was created to easily allow you to mount an apex, power strips, equipment controllers and much more so they are easily accessed an...

Mount your Vortech Pump Controller in style.

Moonlight in the ocean is believed to be as significant as the time spent in full daylight. Moonlight triggers various internal and external biological activities among the many thousands of reef organisms. Many corals continue to grow under moonlight...

The Neptune Systems DŌS Dosing and Fluid Metering System is a popular automatic dosing system that is a perfect fit for the Controller Cabinet when combined with the DŌS faceplate. You’ll be able to hide the unit inside the stand for a cleaner...

Use this cable to connect Apex Systems and modules together. The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex,...

The Neptune Systems DŌS Dosing and Fluid Metering System is a popular automatic dosing system that is a perfect fit for the Controller Cabinet when combined with the DŌS faceplate. You’ll be able to hide the unit inside the stand for a cleaner...

Moonlight in the ocean is believed to be as significant as the time spent in full daylight. Moonlight triggers various internal and external biological activities among the many thousands of reef organisms. Many corals continue to grow under moonlight...

AQUABUS EXTENSION CABLE (M/F)-VARIOUS LENGTHS The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to extend a M/M Aquabus Cable. Remember,...

Apex LED Light Dimming Cable – 2 Channel Use this cable to connect two channels of 0-10V dimmable LED lights to your Apex System or Advanced LED Dimming Module – VDM Use this cable to connect two separate LED color channels from your 0-10V...

Mount your Neptune APEX display in style. with this new APEX Display Holder. Simple Installation Features a simple mounting slot for super easy to mounting and aligning. This kit includes the mount and a mounting screw.

Mount your Neptune APEX display in style. with this new APEX Display Holder. Simple Installation Features a simple mounting slot for super easy to mounting and aligning. This kit includes the mount and a mounting screw.

Trident faceplates provide for a cleaner more flush installation to give your cabinet a higher-end, more custom look. They fit a wide variety of aquarium controllers, pump controllers, and auto top-off (ATO) controllers. Some popular examples...

Moonlight in the ocean is believed to be as significant as the time spent in full daylight. Moonlight triggers various internal and external biological activities among the many thousands of reef organisms. Many corals continue to grow under moonlight...