Plug this probe into your FMM and then place it on any surface where you want to detect stray water. Upon contact with water this probe will communicate to your Apex and alerts or other actions can then take place. Time is so critical when it comes to water on the floor so it is very common to place two of these inside the stand and two outside the stand to have the ultimate protection against a leaky aquarium. Note: The LD-2 will only work with the FMM and cannot be used with the ALD module.
Replace your Temperature Probe, add one for another tank, or put one on your PM2/PM3 module for temperature compensated readings.
Buy this probe if you are:
Replacing an old probe.
Adding...
Neptune Systems Magnetic Probe Rack
Features – MPR:
Organizes up to four probes.
Designed specifically for the Apex Controller probes, a perfect fit for the thicker temp probes.
Built with an...
Plug this probe into your FMM and then place it underneath your carpet near your aquarium. Upon contact with water this probe will communicate to your Apex and alerts or other actions can...
Kit Includes 1x FMM Module, 2x Solid Surface Leak Detection Probe.
Aquarium leaks are one of the most feared events for even the most seasoned aquarist – and for good reason. When it comes to leaks,...
New to the leak detector offerings is the Optical Multi Surface Leak Sensor (LD-3). This is a weighted sensor that is an improved sensor and design over our Solid-Surface Leak Sensor (LD-2)...
This sensor plugs into your FMM and, using reflected infrared light, will signal your Apex when it changes state from being wet to dry or dry to wet. This sensor can be used for constructing your own...
Usually used with a return pump, this flow sensor can be placed in line with the flow on any pipe, connected to the FMM, and communicate to your Apex the flow rate of water through that pipe. The...
This 24VDC powered, normally-closed (NC), solenoid valve has push-fit tubing input and outputs designed for standard 1/4″ tubing. The electrical connection on this solenoid valve fits the DC24...
FMM – FLUID MONITORING MODULE IT DOES SO MUCH!
This is just the module itself without and sensors.
The FMM (Fluid Monitoring Module) is a module that connects to any Apex (Apex(2016), Apex...
Plug this probe into your FMM and then place it underneath your carpet near your aquarium. Upon contact with water this probe will communicate to your Apex and alerts or other actions can...