Apex Auto Top Off

110V power supply for our DC24 accessories like the PMUP, GRO Refugium LED and Solenoid Valve.  You can use these when there are no available DC24 outputs on your EB832 or 1LINK but do have physical 110V outlets available.

The ATK (Automatic Top-off Kit) is a simple, standalone, and complete solution for replacing water lost to evaporation. The new aquarium hobbyist has many challenges, but none is more annoying than the chore of adding water, every day, to make up for...

The PMUP is a multi-purpose pump that can be used for many different tasks on your aquarium.  This listing includes a Power Supply. Automatic Top-Off (ATO) Carbon reactors GFO reactors Biopellet reactors Many other salt or freshwater...

The PMUP is a multi-purpose pump that can be used for many different tasks on your aquarium. Automatic Top-Off (ATO) Carbon reactors GFO reactors Biopellet reactors Many other salt or freshwater uses NEW IN VERSION 2: Automatic shut off when...

This is a power supply for the Neptune Systems FMM, DOS, ATK and Trident.

This 24VDC powered, normally-closed (NC), solenoid valve has push-fit tubing input and outputs designed for standard 1/4″ tubing. The electrical connection on this solenoid valve fits the DC24 accessory ports found on the FMM, 1Link, and Energy Bar...

Plug this probe into your FMM and then place it on any surface where you want to detect stray water. Upon contact with water this probe will communicate to your Apex and alerts or other actions can then take place.  Time is so critical when it...

Plug this probe into your FMM and then place it underneath your carpet near your aquarium. Upon contact with water this probe will communicate to your Apex and alerts or other actions can then take place. Don’t have carpet, see the next...

This sensor plugs into your FMM and, using reflected infrared light, will signal your Apex when it changes state from being wet to dry or dry to wet. This sensor can be used for constructing your own ATO (auto-top-off), as a high-level warning sensor in...

Usually used with aquarium accessories like RODI inputs, calcium reactor feed lines etc., this flow sensor can be placed in line with the flow on 1/4″ tubing, connected to the FMM, and communicate to your Apex the flow rate of water...

FMM – FLUID MONITORING MODULE IT DOES SO MUCH! This is just the module itself without and sensors. The FMM (Fluid Monitoring Module) is a module that connects to any Apex (Apex(2016), Apex Classic, Apex Lite, Apex Jr.) via it’s AquaBus...