Apex Auto Top Off

One of the biggest devastating accidents with an aquarium can be a leak or overflow.  An overflowing tank or leaking piece of equipment can cause a ton of damage especially if you have nice floors around the tank.  The ALD module will hook...

One of the biggest devastating accidents with an aquarium can be a leak or overflow.  An overflowing tank or leaking piece of equipment can cause a ton of damage especially if you have nice floors around the tank.  The ALD module will hook...

110V power supply for our DC24 accessories like the PMUP, GRO Refugium LED and Solenoid Valve.  You can use these when there are no available DC24 outputs on your EB832 or 1LINK but do have physical 110V outlets available.

This is a power supply for the Neptune Systems FMM, DOS, ATK and Trident.

This 24VDC powered, normally-closed (NC), solenoid valve has push-fit tubing input and outputs designed for standard 1/4″ tubing. The electrical connection on this solenoid valve fits the DC24 accessory ports found on the FMM, 1Link, and Energy Bar...

Plug this probe into your FMM and then place it on any surface where you want to detect stray water. Upon contact with water this probe will communicate to your Apex and alerts or other actions can then take place.  Time is so critical when it...

Plug this probe into your FMM and then place it underneath your carpet near your aquarium. Upon contact with water this probe will communicate to your Apex and alerts or other actions can then take place. Don’t have carpet, see the next...

This sensor plugs into your FMM and, using reflected infrared light, will signal your Apex when it changes state from being wet to dry or dry to wet. This sensor can be used for constructing your own ATO (auto-top-off), as a high-level warning sensor in...

Usually used with aquarium accessories like RODI inputs, calcium reactor feed lines etc., this flow sensor can be placed in line with the flow on 1/4″ tubing, connected to the FMM, and communicate to your Apex the flow rate of water...